How Do I Tie a Tie Again

Download Article

Download Article

Take yous graduated across the clip-on tie? Get-go with these helpful instructions, a precipitous-looking tie, a mirror, and some patience, you tin become an expert in tying your own stylish knot. Y'all take several options available, from the versatile Four-in-Hand Knot to the classic Windsor.

If yous're helping someone else put on a tie, see this commodity for instructions from that perspective.

1. 1

   Drape the tie around your cervix. With your collar upwardly and your shirt fully buttoned, place the necktie around your shoulders. Hang the wider finish of the tie on your right side, with the narrow terminate about 12 inches (thirty cm) higher on the left.^[1]

   Tip: Avert spread collars with this small, asymmetric knot.

2. 

   ii

   Cross the wide end over the narrow end. Bring the wide stop to the left side of your body, over the narrow end. Hold the two pieces of cloth together with your left hand, virtually your cervix.

   Ad

3. 

   three

   Loop the wide end under the narrow finish. Let go with your right paw. Constrict it underneath the narrow end, grab the wide end, and pull it back through to your right side.

4. 

   4

   Loop the wide end back over again. Cross it over the narrow terminate one more time, at the same bespeak where your left hand is belongings the knot together.

   Note: The front of the tie should be facing forward again (so the seam is hidden).

5. 

   5

   Pull the wide cease up through the neck loop. Fold the tip of the wide terminate under itself and pull upwards through the neck loop.^[ii]

6. 

   6

   Insert the wide stop down through the front knot. You should have a horizontal knot across the front of your tie. Agree this knot open with your finger and carefully insert the broad end.

7. 7

   Tighten the knot. Hold the narrow end and slide the forepart knot upwards to tighten the tie. Make certain your tie is straight and the length is appropriate, ideally ending at the acme of your belt buckle.

   • Squeeze the sides of the knot gently to create a dimple merely below it.

   Tip: The four-in-hand knot is a little asymmetrical at the cervix. Don't worry about this; it is normal.

8. 

   8

   Tuck the narrow end of the tie into the loop on the back side of the wide cease.

9. 

   9

   Fold your collar downward, and make sure that the tie is covered by the collar all the way around your neck.

Advertisement

1. 1

   Put the necktie around your neck. Make sure the wider end is on the right, and almost 14 inches (36 cm) lower than the thinner side on the left.^[3] The Windsor knot uses a lot of cloth, so the lower terminate should start a bit lower than you would commonly position a tie.

   Tip: Many consider the large, symmetric Windsor knot the near elegant and formal option. Wear it with a spread or wide spread collar.^[iv]

2. 

   ii

   Cross the wide stop over the narrow end. Hold one cease in each hand, then laissez passer each of them to the opposite hand. The wide end should at present be on your left side.^{[5] [6]}

3. 

   3

   Bring the wide end upwardly through the cervix loop. Using your correct manus, hold the two ends where they cantankerous nigh your collar. With your left hand, pull the broad end up through the neck loop from below.

4. 

   four

   Bring your tie back down. Remainder the wide end back on your chest, to the left of the narrow terminate.

5. 

   five

   Fold it end behind the narrow finish. Catch the wide end with your right hand and pull information technology back to the right side of your trunk, nether the narrow end. Concord the knot virtually your collar in place with your left paw.

6. 

   6

   Bring the wide end up to the neck loop from the front. Keep information technology on the right side.

7. 

   seven

   Pull the wide finish through the neck loop. Insert the tip of the broad end and pull through, still on the right side.

   Notation: The underside of the wide end should now be facing forward.

8. 

   8

   Fold the wide cease over the narrow end. Fold it dorsum over from right to left, so the front side is visible again.

9. 

   ix

   Pull the wide end through the neck loop from below. Bring the wide end support through the neck loop 1 last time.

10. x

    Insert the wide end through the front knot. Place the wide terminate through the horizontal knot at the front of the tie. Pull it through.

11. 

    eleven

    Tighten the knot. Concord the base of the front knot and clasp gently from the sides. Slowly pull the wide terminate of the necktie to bring the knot closer to the cervix.

Advertisement

1. one

   Place the tie upside down around your neckband. Unlike most knots, the Pratt knot begins with the tie upside down, so the seam of the tie is facing forward. Hang the wide end of the tie over your right side, and the narrow end over your left side.

   • This medium size knot suits about collars and builds.

2. 2

   Check the position of the broad end. In a knotted necktie, the wide cease should only graze the top of your belt buckle.^[7] At the outset, however, enhance or lower the wide end until it hangs i–2 inches (2.5–5 cm) beneath this point. Every bit a dominion of pollex, the Pratt knot will lift the broad end past this distance equally y'all tie the knot.^[8]

   • The narrow stop of the tie should exist college than the wide end. It volition usually be effectually omphalus level, but this is less important than the wide end's placement.^[9]

3. 3

   Cross the wide end under the narrow cease. Movement the broad end across your trunk to the left side, placing it underneath the narrow finish.

   • Do non motion the narrow cease of the necktie for any office of this knot.^[10] Just agree it steady while you employ the broad end.

4. 

   iv

   Bring the wide terminate upwardly to the loop around the neck. Place the tip on top of the loop, nevertheless on your left side.

5. 

   5

   Pull the wide stop through the neck loop. Insert the wide finish down into the loop from above. Pull information technology through in the same management it lay before, on the left.

6. 

   6

   Fold the wide end over the narrow end, from left to right. This flips the broad end so the seam is no longer visible. The broad end volition extend at an angle off to your right.

7. 

   7

   Pull the broad end upwards through the neck loop. Bring the wide terminate up to your neck loop again, but this fourth dimension from below. Pull it through.

8. 

   8

   Tuck the wide end downwards through the new loop at the front. Your last fold created a horizontal loop at the front of your tie. Tuck the wide finish through this loop, and pull straight down to tighten. The wide end should now rest in front of the narrow end.

9. 

   9

   Slide the knot to conform. Pull down on the broad end to tighten. Slide the front knot upwardly to the base of your collar to fasten the necktie.

   • To create a dimple only below the forepart knot, clasp the sides of the knot gently as yous tighten.^[11]

Advertizing

1. i

   Position the wide finish on the right side. Place the tie effectually your cervix and let the sides hang in front of you. The wide cease should exist on the correct side of your torso, and hang roughly 12 inches (30 cm) lower than the narrow end on the left.^[12]

   • The Half Windsor is a triangular, symmetrical knot suitable for formal occasions. Larger than the Four-in-hand but less bulky than the Windsor, this tin can work with well-nigh neckties and collar types.^[xiii] Neckties made from thicker fabric will likely require a spread or wide spread neckband with this knot.

2. 

   2

   Cross the wide end over the narrow finish. Bring the wide end of the necktie over to your left side, crossing over the narrow end.

3. 

   iii

   Fold the wide end back under the narrow end. Complete a loop effectually the narrow finish and pull the wide end back to the right side.

   • The underside of the broad end should be visible at this point.

4. 

   four

   Take the wide end upward to the neck loop. Enhance the wide end upwards to the loop of necktie at your collar. Keep it on the right side.

5. 

   5

   Pull the broad stop through the loop and to the left. Insert the wide tip downwardly through the loop and pull information technology through from the left side, then it crosses under the narrow end.

6. 

   six

   Fold the wide end over the front end of the narrow end. Bring the wide stop back across the front and onto your correct side.

7. 

   7

   Slide the wide terminate up through the neck loop. Fold the wide end upward through the neck loop a second time.

8. 

   eight

   Insert the wide end down through the front knot. Loosen the front knot with your finger and insert the broad end. Pull it through to residue over the narrow end.

9. 

   9

   Pull on the wide end to tighten. Gently clasp the front knot every bit y'all pull to slide the knot up and create a dimple at the front of your tie.

Advertizement

Add New Question

• Question

  Can I utilise a scarf every bit a tie?

  

  Yep, you can use a scarf as a tie.

• Question

  What type of knot should I employ for schoolhouse?

  

  The four-in-paw knot should work fine for school.

• Question

  What is the quickest way to necktie a necktie?

  

  The 4-in-paw knot should work. Doesn't take more than than a minutes with practice.

• Question

  Should the label exist facing outward instead of touching the front of the shirt?

  

  Information technology should be touching the front end of the shirt for all knots except the Pratt knot.

• Question

  Which methods are more breezy?

  

  The four-in-hand knot is easy and pretty breezy.

• Question

  Can I wearable a Windsor tie to school?

  

  Helter Incendito

  Community Answer

  My son always uses a double Windsor knot for his necktie when he goes to school and it has not presented any bug.

• Question

  How can I remember how to tie a tie if I continue forgetting the steps?

  

  If you lot keep forgetting it e'er helps to write it downwardly. Each step in order neatly will help you remember. Read it a couple times, and practice over and over until y'all don't demand the directions.

• Question

  What is a formal knot to wear with a arrange to a wedding?

  

  I remember one-half windsor knot and traditional windsor knot should work well, because they are more than official and formal.

• Question

  Which type of knot should I utilise for an internship?

  

  Helter Incendito

  Community Answer

  The type of knot should really depend on the size of your collar. If the shirt has a small collar, use a smaller knot like the four in paw. If it's a standard collar, use a Windsor knot.

• Question

  What if I don't know how to necktie a Windsor knot?

  

  Helter Incendito

  Community Answer

  Then you look at the instructions on this page and continue practicing. In that location are also other pages that explain how it is washed. Employ your favorite search engine.

Show more answers

Inquire a Question

200 characters left

Include your email accost to become a bulletin when this question is answered.

Submit

Advertising

VideoRead Video Transcript

• To make a dimple, hold the elevation blade on both edges, then pull it down gently until the top blade starts to tighten. A slightly convex shape should appear close to the knot. Use your pollex and forefinger to press the lesser of the knot into a V-shape and the convex will deepen to class the dimple.

• If your necktie has a loop underneath the broad side of the tie, y'all may slide the narrow side through that loop to forestall information technology from "peeking" from behind the wide side of the necktie.

• Left-handed people may find it easier to switch the starting positions of the wide and narrow ends. If you practise this, switch all "left" and "right" instructions.

• Ideally, the tip of the tie should graze the peak of your belt buckle. It'southward all right if the necktie dips downwardly to the lesser of the belt buckle ("Italian style"). If information technology'southward any lower, try a knot that uses plenty of material (such as the Windsor), or switch to a shorter tie.^[14] Similarly, if the tie ends above your belt, purchase a longer tie or try the Pratt knot, which doesn't use much fabric in the knot.

• Brand a mnemonic device to help you call up these steps, such as the word OUAT, which is an acronym for over, under, around and through.

• If y'all're helping someone necktie their necktie, necktie information technology on yourself first since it volition be easier to make the proportions accurate. Then, before you tighten the knot, transfer the tie to their neck.^[fifteen]

Advertisement

Nigh This Article

Article Summary Ten

The all-time mode to tie a tie for beginners is the 4-in-hand knot. Step 1. Push the top button of your shirt, and fold your collar up. Step 2. Hang the necktie effectually your collar then that the wide end is on your correct side, about 4 inches below the narrow terminate. Step 3. Cross the wide end in front of the narrow finish. Step 4. Bring the wide end behind the narrow end, and pull the wide end from left to correct. Hold the narrow stop steady throughout. Pace five. Cross the wide terminate in front of the narrow stop from right to left. Footstep six. Pull the wide finish upwardly through the cervix loop, then push the wide end downward through the loop you created in front. Footstep 7. Hold the narrow finish in 1 hand, then pull the wide end to tighten the knot. Straighten the knot every bit needed. Pace 8. Cheque to brand sure that the terminate of the necktie is about at the middle of your belt buckle, and tuck the narrow terminate of the necktie into the loop on the back side of the wide end. Step ix. Fold your collar down, and make certain that the tie is covered past the collar all the mode around your cervix.

Did this summary help you?

Cheers to all authors for creating a page that has been read 4,916,785 times.

Did this article help yous?

palaciobuttaide.blogspot.com

Source: https://www.wikihow.com/Tie-a-Tie

Share this post